Flush Diaphragm Pressure Transducer |
||
|
||
Features
|
 |
|
| . | ||
| Performance Specifications @ 72°F (22°C) | ||
Flush Diaphragm Pressure Transducer |
||
|
||
Features
|
|
|
| . | ||
| Performance Specifications @ 72°F (22°C) | ||
| Linearity & Hysteresis (B.F.S.L.) | < ± 0.35% (± 0.20% typical) |
| Repeatability | Within ± 0.08% F.S.O. |
| Resolution | Infinite |
| Operating Temperature Range | -65° to 300°F, (-54° to 149°C) |
| Compensated Temperature Range | 0° to 250°F, (-18° to 121°C) |
| Thermal Zero Shift | < ± 0.01% F.S.O./°F (< ± 0.018% F.S.O./°C) |
| Thermal Span Shift | < ± 0.01% F.S.O./°F (< ± 0.018% F.S.O./°C) |
| Acceleration effect | < ± 0.01% F.S.O. per "G" all planes |
| Electrical Specifications |
| Bridge | Four active arm bonded strain gage |
| Input & Output Resistance | 350 or 5000 Ohm nominal |
| Supply Voltage | 1 to 10
VDC regulated, 350 Ohm 1 to 24 VDC regulated, 5000 Ohm (calibrated at 10 VDC) |
| Full Scale Output (Sensitivity) | 2.0 mV/V nominal with ± 1% option available |
| Zero Balance | ± 2% F.S.O. |
| Shunt Calibration | 80% ± 5% F.S.O. (value noted on calibration sheet) |
| Resistance to Ground | 1000 MegOhms minimum @ 50 VDC |
| CE Marked | Conforms with EN 55011:1991 Class A, & with applicable RF immunity requirements of EN 50082-2:1995 when used with CE approved equipment |
| Mechanical Specifications Dimensional Outline Drawing |
| Pressure Ranges | 250, 300, 500, 1k, 1.5k, 2k, 3k, 5k, 10k |
| Negative Pressure | Usable to full vacuum |
| Pressure Limit | 150% F.S. without calibration shift |
| Burst Pressure | > 300% F.S. |
| Wetted Material | 15-5 PH stainless steel heat treated |
| Weight | 3 ounces approximately |
| Process Connections | MS33656-5, M14X1.25-6g, MS33656-8 |
| Specifications are subject to change without notice. Transducer is supplied with NIST traceable certificate of conformance. 13 point calibration certificate is also available. |
